This acrylic internally threaded hide-it will fit any Industrial Strength brand stainless steel, titanium and acrylic jewelry*. The acrylic hide-it is countersunk for a precision fit.
* SPECIAL NOTE: THE 6 GAUGE HIDE-IT DOES NOT FIT ACRYLIC JEWELRY. IT ONLY FITS STAINLESS STEEL AND TITANIUM JEWELRY.
NOTE: do not use alcohol on acrylic, it will crack.
This threaded end will fit Industrial Strength brand internally threaded jewelry, but may not fit your other brand jewelry if purchased elsewhere (due to possible differences in threading). The gauge of the end must be the same gauge as the jewelry it threads into.
Adding your own review is easy! Select all the attributes, such as gauge and size, of the jewelry you are reviewing, then click the "Submit review" link above.
These, while good in theory, were completely pointless for me. They're massive and made my vertical labret look wayy more noticeable than my normal 3mm flat disk ends. Would love for these to come in disks and/or smaller sizes. Also super expensive for what they are. Not super pleased.
- Lorraine, Gorham, ME, UNITED STATES - 10/11/2012
I bought two of these with the intention of making my lip and nostril piercings less obvious, and was disappointed to find that they didnt just make my piercing look like a pimple, they made my piercings about four times more obvious than with the titanium jewelry I wear daily. Definitely not something I'll be recommending in the future to other people.
It fooled my mom which is what I was going for!! I was worried about the flat edge around the bottom since this was going in my mouth. It was very comfy actually. I strongly advise the little gripper tool to put it in such an awkward location however. Took me nearly 10 mins without it!